Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Energy-Efficient Windows in Westwood Lakes, FL: What the Job Actually Costs and How It Runs
Replacing the original single-pane and jalousie windows on a Westwood Lakes CBS home with energy-efficient units typically runs $4,500 – $15,000 for whole-house window replacement, and a typical 3-bedroom house is finished in 2 to 4 working days. Impact-rated energy-efficient windows in Westwood Lakes land higher, at $8,000 – $25,000, because they carry both the solar-heat gain rating that cuts your summer power bill and the wind-load rating Miami-Dade County requires. Call (844) 761-9356 for a free on-site estimate with written, line-item pricing.
How we run an energy-efficient window job in Westwood Lakes, start to finish
Window replacement looks simple from the street. Under the surface it’s a five-stage job, and the stages that matter most happen before a single unit is ordered. Here’s the real sequence.
Stage 1: Measure, inspection, and product selection (day 1, about 90 minutes)
We measure every opening, check the existing frames for rot, settlement, and old flashing, and look at the roof-wall junctions above each window, since that’s where water tends to enter these homes. You’ll decide the product line, glass package, and frame material at this visit. This is also where we confirm which units need a permit and which are simple like-for-like swaps.
Stage 2: Ordering and permit filing (1 to 3 weeks of waiting)
Most quality window lines are ordered, not pulled off a shelf, so plan on 2 to 4 weeks for delivery, with hurricane-rated units sometimes running longer. If your home was built in the late 1950s through the 1970s and the openings are being resized or the glass is changing, we file with Miami-Dade County and schedule the inspection. You’ll sign off on the final spec sheet here.
Stage 3: Protection and demo (day 1 of install, 3 to 5 hours)
Floors and furniture get covered, and we pull the old units one elevation at a time rather than opening up every wall at once. Your house stays weather-tight overnight. On CBS walls we cut back to solid masonry and clean the opening before anything new goes in.
Stage 4: Setting and sealing (days 1 to 3, most of the labor)
New units get set, shimmed, shimmed again, and fastened to the structural frame. Then comes the flashing and sealant work, which is where a cheap install shows up two summers later. We use exterior-grade flashing at the head and sill of every opening and finish with a backer rod and sealant joint that can move with the wall.
Stage 5: Trim, insulation, and inspection sign-off (days 2 to 4)
Interior trim goes back, gaps get insulated, and the final walkthrough happens with you in the room. If a permit was pulled, the inspection is scheduled and passed before we consider the job closed. You get the completion paperwork and the warranty in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The energy-efficient window options you’ll actually be choosing between
Energy performance on a South Florida window comes down to the glass package and the frame, in that order. Here’s what the real choices look like.
- Low-E glass with argon fill: The standard energy upgrade. Reflects solar heat, keeps rooms cooler, and cuts summer cooling costs. Moderate cost, strong long-term payoff.
- Single-hung vs. sliding vs. casement: Single-hung is the most economical and easiest to seal. Sliding is common on the wide openings in these homes but relies on a good weather-strip to hold its rating. Casement seals tightest but costs more and needs clear swing space.
- Vinyl frames: The budget-friendly choice. Good thermal performance, low maintenance, and holds up fine in South Florida heat. Doesn’t take paint well and can discolor on a west-facing wall over time.
- Aluminum frames: Stronger and thinner, which suits tight openings and modern profiles. Aluminum conducts heat, so it needs a thermal break to perform well as an energy-efficient window.
- Impact-rated glass: Adds storm protection and usually a lower insurance premium. Costs more per unit, but it often eliminates the need for shutters.
We’re authorized to install Andersen and Pella products, and we’ll quote the same job in two tiers so you can see what the energy upgrade actually costs. Picking the right glass for a west-facing window on a 1960s CBS house matters more than the frame brand printed on the sticker.
What energy-efficient windows cost in Westwood Lakes, FL
Whole-house energy-efficient window replacement in Westwood Lakes runs $4,500 – $15,000, and impact-rated energy-efficient units run $8,000 – $25,000. Your number lands inside that range based on five things.
- Number and size of openings: A 3-bedroom house may have 12 to 16 openings. Each one added is real money.
- Glass package: Low-E with argon versus a basic clear unit is a modest per-window jump. Impact-plus-Low-E is the big one.
- Frame condition: Old jalousie openings need framing and sill work before a new unit fits, which adds labor.
- Permit scope: Like-for-like swaps are lighter on paperwork. Resizing openings triggers full plan review.
- Trim and finish: Interior trim restoration and exterior finishes are line items, not freebies.
Every written estimate breaks out materials, labor, permit costs, and any framing or flashing repair separately. We don’t quote a number you can’t see inside of. No-hassle upfront pricing means the number you sign is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Westwood Lakes homes specifically do to this job
Westwood Lakes is a built-out, post-war suburb in ZIP 33165, which means nearly every energy-efficient window project here is a retrofit on a 1950s – 1970s concrete-block home, not new construction. Those homes were built with jalousie windows and original flashing that were never designed for today’s storm intensity, so after a heavy summer downpour it’s common to find hidden water intrusion at the roof-wall junctions and window openings. That’s the first thing we check. Miami-Dade County’s post-Surfside recertification and 40-year inspection rules also apply to aging CBS homes here, and low-lying land just west of the urban core brings flood-zone elevation requirements into the conversation when openings are resized. So a window job in Westwood Lakes is partly an energy upgrade and partly a correction of what the original 1960s build got wrong. If you’re pairing this with exterior work, homeowners often add Fence Repair in Westwood Lakes at the same time, and we cover the whole neighborhood through our Westwood Lakes service area.
Serving Westwood Lakes, FL – Our Local Coverage Area
We serve Westwood Lakes and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked questions about energy-efficient windows in Westwood Lakes
Most Westwood Lakes homes are done in 2 to 4 working days once the units arrive, and order-to-delivery is typically 2 to 4 weeks. The install itself is fast; the lead time on the units is what shapes the schedule. Call (844) 761-9356 and we’ll give you a realistic date range on your first call.
Yes, if the openings are resized or the glass and wind-load rating change. Like-for-like replacements with the same opening size are handled differently. Miami-Dade County requires wind-load compliance on these homes, and our estimates state permit scope up front so there’s no surprise later. Call (844) 761-9356 to confirm your situation.
They usually do, most noticeably on west- and south-facing rooms during June through November. Low-E glass with argon fill is the main driver. We quote the same openings in two glass tiers so you can compare cost against the comfort gain before you decide.
In most Westwood Lakes homes, yes. A standard retrofit keeps your existing openings and interior finishes intact. Structural changes only come up when a wall is opened for a room addition, and that’s a different scope we’d quote separately.
Every project we install is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. Manufacturer warranties on the units run alongside that, and you get both in writing at the walkthrough. Call (844) 761-9356 for a free estimate.
If you’re considering other exterior upgrades, our Windows & Doors service covers the full range, and you can read about the broader Windows & Doors in Westwood Lakes scope and Iron Fence in Westwood Lakes work homeowners often pair with a window project.
Get a free estimate for energy-efficient windows in Westwood Lakes
Call (844) 761-9356 to schedule a free on-site estimate for energy-efficient windows in Westwood Lakes. We’ll measure every opening, check the frames and flashing, and hand you a written line-item quote with permit scope spelled out. Calls are answered by a live person, day or night, and our technicians are background-checked and arrive in uniform. Financing at 0% for 18 months is available, along with $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.