Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Iron Fence in Westwood Lakes, FL: What It Costs and How Long It Takes
An iron fence in Westwood Lakes, FL typically runs $3,500 – $9,000, and most properties here are finished in 3 to 6 working days once the layout is staked and utility locates are cleared. The number swings on linear footage, gate count, and whether you’re fencing a pool enclosure line or a full street frontage. Call (844) 761-9356 and we’ll walk the property with you, mark the run, and put real numbers in writing the same week.
How an Iron Fence Actually Goes In: Day by Day
Iron fence work on a Westwood Lakes lot is mostly scheduling and access, not demolition. Here’s the real sequence, and what you’ll be asked to decide at each stage.
Stage 1: Site walk and layout (day 1, about 90 minutes)
We measure the run, check the property survey against the plat, and mark post positions with paint. This is where you decide gate placement and swing direction, which matters more than people expect on tight interior lots where a gate that swings out can block the driveway apron. Utility locates get called in before anything is dug.
Stage 2: Permitting and HOA review (days 1 – 10, in parallel)
Most residential fence lines in Miami-Dade County require a permit, and Westwood Lakes falls inside that. If your subdivision has deed restrictions, the architectural review runs alongside it. We submit, you sign, we track it. Nothing gets dug until the permit is in hand, which is the honest reason your start date may sit a week or two out.
Stage 3: Post setting and footing (days 1 – 2 of construction)
Posts go in first, set in concrete footings below grade. On this neighborhood’s low-lying lots, footing depth and drainage around each post hole get watched closely, because a post sitting in standing water rusts from the inside out no matter what finish it wears. Spacing is set to the panel width so the rails land square.
Stage 4: Panel and gate hang (days 2 – 4)
Rails, pickets, and gate frames go up, then we set hinges, latches, and any self-closing hardware. This is the stage where you decide finishes and hardware in advance; a gate ordered late holds the whole job, so we lock the gate spec at the estimate, not on install day.
Stage 5: Inspection and touch-up (final day)
The county inspector signs off, we touch up any field cuts with matching coating, and we walk the line with you. That walk is where you’ll hear what to check after a storm.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make: Material, Style, and Hardware
Iron fence isn’t one product. The pick you make here drives both the price and how the fence looks in ten years.
- Wrought iron (solid bar): The real thing, welded and hand-finished. Heaviest, best looking, and the most expensive end of the range. Suits a full frontage on a larger lot and holds resale value.
- Tubular steel: The practical middle. Panels arrive pre-assembled, powder-coated, and screwed or welded together. Most Westwood Lakes jobs land here because it delivers the iron look at a lower number and goes up faster.
- Aluminum resembling iron: Lighter, rust-proof, and the cheapest way into the look. Fine for a short run or a decorative section, less convincing up close.
- Powder-coat finish: Worth the upgrade in South Florida. Choose satin black or bronze; bare or thin-coated steel rusts fast in this humidity.
- Gate hardware: Standard latch versus self-closing and self-latching hardware, which pool safety rules often require. Decide this at estimate time.
For a shed or outbuilding inside the fence line, homeowners often pair this with a Tuff Shed install so the structure and the fence go in on the same schedule.
What Iron Fence Costs in Westwood Lakes, FL
Plan on $3,500 – $9,000 for a typical residential iron fence in Westwood Lakes. Here’s what moves a job toward the low or high end:
- Linear footage: The biggest lever. A short side-yard run sits near the bottom; a full perimeter pushes the top.
- Material grade: Tubular steel is roughly the middle of the range; solid wrought iron and custom panels add meaningfully.
- Gate count and automation: Each walk gate adds cost, and a driveway gate with an opener is a separate line item entirely.
- Site conditions: Root-bound lines, old concrete footings to break out, or a run that crosses a buried utility all add labor.
- Permit and HOA fees: County permit fees and any architectural review charges are pass-through costs.
Your written estimate itemizes footage, post count, gate spec, finish, permit, and disposal. What it typically doesn’t cover: landscaping repair along the trench line, sod replacement, or fence removal if an old line has to come out first (that’s quoted separately once we see it).
See the difference
Before
After
Before
After
Before
AfterWhat Westwood Lakes Homes Specifically Do to This Job
Westwood Lakes is a built-out, post-war suburb (ZIP 33165), and nearly every fence here is a renovation on a 1950s – 1970s lot, not new construction. That changes the work. Property lines on these older plats often disagree with what’s actually built, so we start by matching the survey to the ground before a single post is dug. Many yards already hold old chain link footings or tree roots that have to come out. Because the neighborhood sits on low-lying ground, post holes collect water after the summer downpours, and we set footings to shed it rather than sit in it. Homes here are mostly single-story CBS, often with flat or low-pitch roofs, so front-yard fence lines and roof drainage interact: a run placed without thought can push runoff against the house. Down the interior streets, hidden water intrusion at roof-wall junctions is a pattern contractors learn to check first, and it’s the same instinct that tells us where a fence line should and shouldn’t sit.
Serving Westwood Lakes, FL – Our Local Coverage Area
We serve Westwood Lakes and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Iron Fence in Westwood Lakes
Construction itself takes 3 to 6 working days for most residential jobs. The permit and HOA review adds roughly one to two weeks before we can dig, so total time from signed estimate to inspection runs about 2 to 4 weeks. Call (844) 761-9356 for a date range based on your specific lot.
Usually yes. Miami-Dade County requires a permit for most residential fence lines, and Westwood Lakes properties fall under that. We pull the permit and handle the inspection. If your subdivision has an HOA, plan on architectural review too.
Yes, in almost every case. Fence posts are shallow footings along the property line, well clear of your plumbing and slab. The one exception: if a run crosses a buried utility or irrigation line, the locate tells us and we adjust the post spacing.
Most jobs land between $3,500 and $9,000. Linear footage, material grade, gate count, and site conditions are the levers. Call (844) 761-9356 for an exact written quote; estimates are free.
Every Groundwork iron fence is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. If your project runs over $10,000, ask about our $1,000 off promotion and 0% financing for 18 months.
Get Your Iron Fence Priced in Westwood Lakes
We start with a free on-site estimate across Westwood Lakes. We’ll mark the run, check the survey, and hand you a written, itemized quote covering footage, gates, finish, and permit. If the fence is part of a full Fence Installation in Westwood Lakes project, we’ll scope both together so nothing gets ordered twice. See our Fence Installation service for the wider picture, and if you’re planning other yard work, homeowners often pair this with Patios, Walkways & Pool Decks in Westwood Lakes or an ADU Design & Permitting in Westwood Lakes. Call (844) 761-9356.
Written by the team at Groundwork Construction Co. of The Hammocks.