Roofing
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Metal Roofing in Westwood Lakes, FL: What It Takes and What It Costs
A metal roof installation in Westwood Lakes typically runs $15,000 to $40,000 for a full tear-off and replacement on a single-story CBS home, and most projects take 5 to 10 working days from demo to final inspection. That range covers standing seam and exposed-fastener panels, underlayment, trim, and Miami-Dade product approval for the assembly you choose. Your exact number depends on roof size, pitch, the shape of the existing deck, and what we find under the old shingles. Call (844) 761-9356 to schedule a free on-site estimate – we’ll measure the roof and put the number in writing.
How a Metal Roof Goes On: Stage by Stage
Metal roofing isn’t a one-day drop. Here’s the real sequence, roughly how long each stage takes, and what you decide along the way.
Stage 1: Roof inspection and measurement (day 1)
We get on the roof, check the deck for soft spots, look at how the old roof ties into walls and valleys, and measure every plane and penetration. You decide the panel profile and color by the end of this visit. On a lot of Westwood Lakes CBS homes, this is also where we confirm whether the existing flat or low-pitch section needs a structural review before we commit to a metal system.
Stage 2: Tear-off and deck repair (days 1 – 3)
Old shingles or panels come off, and the deck gets inspected board by board. Rotted sheathing gets replaced and any fascia or drip edge that’s failing gets addressed. You’ll sign off on any deck repair before we proceed – nothing gets added without your approval. The tear-off usually takes one to three days depending on roof size and how much decking needs work.
Stage 3: Underlayment and flashing (days 2 – 4)
We lay down the underlayment the panel manufacturer requires (this matters for the warranty), then install the flashing at valleys, chimney, roof-to-wall junctions, and around any penetrations. This is the stage that keeps water out for the next 30-plus years, so we don’t rush it. Your decision here is already made – the underlayment is part of the spec you approved.
Stage 4: Panel installation (days 3 – 7)
Panels go up from the eave up, in the order that keeps the roof watertight at the end of each day. Standing seam panels are roll-formed on site or delivered pre-cut, depending on the profile. Exposed-fastener panels install faster but need their screws set at the correct torque and spacing. Most of a Westwood Lakes metal roof’s visible work happens in these four days.
Stage 5: Trim, cleanup, and final inspection (days 7 – 10)
Ridge caps, gable trim, and any valley metal get finished, then the site gets swept for nails and debris. If the assembly requires a final inspection under your permit, that’s scheduled here. You’ll walk the roof with us before we hand over the 730-Day Done Right Promise in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Metal roofs aren’t one product. Here’s what actually gets picked between on a Westwood Lakes project and the honest trade-offs:
- Standing seam panels – the most common choice for South Florida. Concealed fasteners, cleaner look, and the assembly that holds up best in wind. Costs more upfront than exposed-fastener systems.
- Exposed-fastener (screw-down) panels – a lower entry point and faster install. The trade-off: screws sit through the panel and can back out over years, so they need checking. Fine for sheds and additions, less ideal on the main house.
- Panel finish (Kynar 500 vs. SMP) – a Kynar finish holds color longer in our sun and costs a bit more. SMP finishes are a real budget option but fade sooner.
- Panel profile and gauge – a 24-gauge panel with a deeper rib performs better against wind uplift. A thinner gauge and lower rib is cheaper and rarely worth the savings on a coastal-zone home.
- Underlayment spec – a peel-and-stick membrane or a synthetic underlayment. The peel-and-stick costs more but is the safer call on a CBS roof with any deck irregularities.
If you’re pairing the roof with new windows, homeowners often pair this with Window Replacement in Westwood Lakes so the flashing and window rough-in are handled in one pass.
What Metal Roofing Costs in Westwood Lakes, FL
Most metal roofs here land in the $15,000 – $40,000 range. Below that and you’re usually on a small roof with an exposed-fastener panel; above it and you’re on a complex roof with standing seam and deck repairs.
What pushes a job toward the high end:
- Roof size and pitch. A steep pitch or a roof with many planes, valleys, and dormers takes more material and more labor.
- Deck condition. CBS homes from the 1960s often have sheathing that needs replacing once the old roof comes off. Every sheet of new decking adds to the number.
- Panel and finish grade. A 24-gauge Kynar standing seam panel runs materially more than a thinner exposed-fastener system.
- Existing penetrations. Skylights, chimneys, vents, and AC platforms all need flashing detail and add labor.
- Permit scope and inspection requirements. A Miami-Dade permit with a wind-mitigation component and a final inspection is part of the cost, not an add-on.
Your written estimate from us is line-itemed: tear-off, deck repair allowance, underlayment spec, panels, trim, labor, permits, and disposal. The number you see is the number you pay. The 730-Day Done Right Promise backs the workmanship. Call (844) 761-9356 for an exact quote – estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat Westwood Lakes Homes Specifically Do to This Job
Westwood Lakes is a built-out post-war suburb – nearly every metal roof we install here is a renovation on a 1950s – 1970s CBS home, not new construction. That matters because the roof deck, the flashing at the roof-to-wall junctions, and the state of the existing concrete-block parapet all have to be checked before we commit to any metal system. Miami-Dade’s post-Surfside recertification and 40-year inspection rules also come into play on the older homes in this ZIP (33165) – we work with the inspection schedule rather than around it. On the flat and low-pitch sections common on these homes, the run-off after a summer downpour often shows up as water intrusion at the roof-wall junctions, and a metal roof assembly with a proper peel-and-stick underlayment is a straight fix for that. If you’re planning a bigger scope, this is often part of a full Roofing in Westwood Lakes project where the metal section is one component. For a quick standalone metal install without a full re-roof, our Roofing service team handles the smaller scopes too.
Serving Westwood Lakes, FL – Our Local Coverage Area
We serve Westwood Lakes and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Metal Roofing in Westwood Lakes
Most metal roof installations here take 5 to 10 working days from tear-off to final inspection, depending on roof size, pitch, and how much deck repair we find.
Yes. Miami-Dade County requires a permit for any re-roof, and the panel assembly needs to carry a Miami-Dade product approval – we pull the permit and pass the inspection as part of the job, and we handle it for you.
Almost always, yes. A standard metal re-roof doesn’t touch plumbing or structure – only if the inspection turns up a structural issue at the deck or a parapet that needs correction would that conversation come up, and we’d show you what we found before adding scope.
Most projects land between $15,000 and $40,000 depending on square footage, panel profile, finish grade, and deck condition. Call (844) 761-9356 for an exact quote – estimates are free.
The 730-Day Done Right Promise covers our workmanship for two full years – if it’s not right, we make it right. The panel manufacturer also warrants the material itself; we’ll walk you through that paperwork before the job starts.
Get a Free Metal Roofing Estimate in Westwood Lakes
Call (844) 761-9356 to schedule your free on-site estimate for metal roofing in Westwood Lakes. You’ll speak to a live person – no voicemail – and we’ll measure the roof, talk through standing seam versus exposed fasteners, and hand you a line-itemed written quote with no surprise change orders. If your project spans the windows or doors too, homeowners often pair this with Impact Windows & Doors in Westwood Lakes. We serve all of Westwood Lakes and the surrounding area.
Written by the team at Groundwork Construction Co. of The Hammocks.