Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Aluminum Fence in Three Lakes, FL: What It Costs and What It Takes
An aluminum fence in Three Lakes, FL typically runs $4,000 – $10,000 for most residential lots, with the majority of single-family properties landing between $5,500 and $8,000. Most jobs take 2 – 4 days once materials are on site, and the long lead time is usually the Miami-Dade product approval and permit, not the build itself. Call (844) 761-9356 to schedule a free on-site estimate.
How an Aluminum Fence Goes In, Stage by Stage
Aluminum fencing looks simple from the curb. It isn’t. The panel is prefabricated, but everything under it and around it decides whether the fence is still true in fifteen years or leaning after the third wet season.
Stage 1: Site visit and layout (day of estimate). We walk the property line, confirm the fence run against the plat, and check what’s underground. In Three Lakes, irrigation lines, pool bond wiring, and the occasional aging cast-iron drain line run close to where posts go. You decide the run, the height, and gate locations at this visit; we mark them with you. A written line-item quote follows.
Stage 2: Permit and product approval (1 – 3 weeks). Miami-Dade County requires a permit for residential fencing, and aluminum products need to be on the county’s approved product list or carry a current Notice of Acceptance. For aluminum in a non-HVHZ application this is straightforward, but it’s still a review step, and the HOA runs its own approval in parallel. You’ll need to submit architectural drawings to the HOA if your community requires it; we supply the spec sheet and layout. This is where jobs stall if nobody is managing it.
Stage 3: Utility locate and layout (day 1 on site). We call for locates and mark the line. Posts get set in concrete footings sized to the local soil and the panel height; 4-foot panels take shorter footings than 6-foot privacy-height runs. This is a full day on a typical Three Lakes lot. You don’t need to be home, but you should confirm gate swing direction before we pour.
Stage 4: Build and hang (days 2 – 3). Sections bolt together, gates hang and get adjusted for clearance and latch alignment. On a 150-linear-foot run, this is two full days for a crew. On a small side-yard run, it fits in one.
Stage 5: Inspection and final walk (day 3 – 4). The county inspector signs off on posts, footings, and setbacks. We walk the fence with you and show you the workmanship warranty in writing. Our aluminum fence work is covered by the 730-Day Done Right Promise, so if a gate sags or a post shifts, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Aluminum fencing is not one product. What you select changes both the number and how the fence ages in South Florida sun and salt air.
- Residential vs. industrial grade. Residential aluminum (roughly 0.050 – 0.062 inch wall thickness) is fine for most Three Lakes backyards. Industrial grade (0.075 inch and up) costs 20 – 35% more and is worth it on pool barriers and long unsupported spans.
- Panel style. Two-rail, three-rail, and picket styles are the common picks. Three-rail reads cleaner on sloping lots; two-rail with pressed points is the classic pool barrier look. Decide this before the permit is submitted, because the spec goes on the drawings.
- Finish. Factory powder coat in black, bronze, or white is standard and holds up better in coastal sun than a field-applied paint. Textured finishes hide scuffs from lawn equipment.
- Pool code compliance. If the fence is a pool barrier, it has to meet the Florida pool safety code on height, spacing, and self-closing, self-latching gates. Not every panel style qualifies. We check this at the estimate so you don’t order the wrong thing.
- Gates. A pedestrian gate, a double driveway gate, or both. Driveway gates on aluminum runs usually need heavier posts and a drop rod; expect the gate to be the single biggest line item after the panels.
- Rackable vs. level panels. Rackable panels follow grade changes without stepping. On the gently sloped lots common off 137th Avenue, racking reduces the number of stepped transitions and looks better.
Barrette makes an aluminum line worth comparing against the commodity imports if the run is long or the fence faces the street. Therma-Tru and ViewLux are the names we typically discuss when homeowners pair the fence with a front entry door upgrade at the same time.
What Aluminum Fence Costs in Three Lakes, FL
Budget $4,000 – $10,000 for residential aluminum fencing in Three Lakes. A typical 100 – 150 linear-foot backyard run with one gate lands near the middle of that range.
- Linear footage and height: 4-foot panels cost less per foot than 5- or 6-foot privacy-height runs. A 200-foot perimeter is a materially bigger number than a 90-foot side yard.
- Grade and wall thickness: industrial-grade aluminum adds 20 – 35% versus residential grade.
- Gate count and type: a pedestrian gate is a modest add; a wide double driveway gate adds significantly to material and footing cost.
- Site conditions: demo of an existing fence, root removal, or a run through limestone-heavy soil raises labor. Flat, cleared ground keeps it at the low end.
- Permit and HOA scope: some runs need only a county fence permit; some also need pool barrier compliance review or HOA architectural approval, each adding time and a fee.
Our written estimate includes materials, labor, footings, concrete, gate hardware, permit pull, and final inspection. It typically does not include removal of an existing fence unless you ask for it as a line item, irrigation relocation, or landscaping repair after install. Upfront pricing, no surprises means the number on the quote is the number you pay unless you change the scope mid-job.
See the difference
Before
After
Before
After
Before
AfterWhat Three Lakes Homes Specifically Do to an Aluminum Fence Job
Three Lakes is a built-out 1980s – 90s suburban pocket of western Kendall, ZIP 33186. Nearly every project here is a remodel, re-roof, or impact-window upgrade on an aging Mediterranean-style concrete-block home, not new construction. That changes fencing more than you’d think. These lots are tight and HOA-governed, so staging materials and getting equipment to the side yard without crossing a neighbor’s lawn takes planning. The soil is Sandy, and footings on 6-foot pools barriers need to be sized generously; shallow concrete is why you see leaning aluminum fences in this neighborhood after a storm season. On the housing stock itself, most of the aluminum fencing we replace in Three Lakes is original or one-generation-old fence installed when these homes were built, often with failing powder coat and a sagging gate latch. Wind matters too: the county’s High-Velocity Hurricane Zone standards drive fence product approvals and post anchoring requirements, and the May – November storm season is when post-storm panel damage and track damage show up in Three Lakes especially. If the fence is part of a full Fence Installation in Three Lakes scope, we coordinate that schedule so permits and inspections run in one pass rather than two.
Serving Three Lakes, FL – Our Local Coverage Area
We serve Three Lakes and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Aluminum Fence in Three Lakes
Yes. Miami-Dade County requires a fence permit for residential aluminum fence work in Three Lakes, and the aluminum product itself has to be on the county’s approved product list. We pull the permit and manage the inspection as part of the job. Call (844) 761-9356 for an estimate that includes the permit cost.
The build itself takes 2 – 4 days on a typical Three Lakes lot. The full job runs longer once you add permit and HOA approval, which is where most of the calendar time goes. Call (844) 761-9356 and we’ll give you a realistic calendar for your run.
Usually yes, with planning. Post locations are set around irrigation, pool bond wiring, and drain lines, and we locate utilities before digging. Relocating a sprinkler head is minor; relocating a pool bond wire takes coordination. Call (844) 761-9356 so we can walk the line with you before anything is ordered.
Expect $4,000 – $10,000, with the middle of that range being most common for a single-family backyard run with one gate. Linear footage, height, grade, gates, and permit scope move the number. Call (844) 761-9356 for a free written quote.
All of our aluminum fence work is covered by the 730-Day Done Right Promise. If anything we installed isn’t right, we make it right, and that includes gate hardware and post stability, not just the panel finish. Call (844) 761-9356 to review the warranty terms before you sign anything.
Get a Free Aluminum Fence Estimate in Three Lakes
Call (844) 761-9356 to schedule a free on-site estimate for aluminum fence work in Three Lakes. A live person answers the phone, around the clock, so there’s no voicemail and no waiting for Monday. We walk the line with you, talk through style, gates, and pool code, and leave you with a written line-item quote. No pressure to sign on the spot. If you’re already planning other exterior work, homeowners often pair this with Driveway Repair & Replacement in Three Lakes or Patios, Walkways & Pool Decks in Three Lakes, and we coordinate it in one visit through our Fence Installation service.
Written by the team at Groundwork Construction Co.