Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Three Lakes, FL: What It Costs and How Fast It Goes Up
A chain link fence in Three Lakes, FL typically runs $3,500 to $9,000 installed, and most residential jobs close out in one to three days once the permit clears. The work itself is quick; the county side is what sets your calendar. You’ll pick height, gauge, and gate layout up front, we set posts and stretch the mesh, and you end with a clean, code-fine fence around a 33186 lot that was probably fenced once already, decades ago. Call (844) 761-9356 for a free on-site estimate and a written, line-item quote.
How a chain link job actually runs, start to finish
Most contractors wave at the fence and say “about a week.” Here’s the actual sequence, with the decisions sitting in front of you at each stage.
Day 1 morning: layout and utility locate
We walk the property line with you and mark post spacing, corner posts, end posts, and gate openings. Before anyone digs, Sunshine 811 gets called so buried utilities get flagged. On these older Three Lakes lots, irrigation lines and old cable runs are common and we’d rather find them with a flag than a shovel. You confirm the exact run and where you want the gate to swing at this stage, not later.
Day 1 to 2: posts, concrete, cure
Holes go down, terminal posts get set deeper than line posts, and each one is set in concrete. That concrete needs time to cure before the mesh goes up under tension, so posts usually sit overnight. This is the part you can’t rush on a chain link fence without the whole run going wavy a season later. Corner, end, and gate posts carry the load, and we set them accordingly.
Day 2 to 3: rails, mesh, tension
Top rail goes in, the fabric gets stretched and tied off, and the tension wire at the bottom locks the run to grade. Fabric height and gauge are what you’re paying for here, so this is where a 4-foot residential roll and a heavier-gauge system visibly separate. Gates get hung and we test the swing before we call it done.
Final walkthrough
We walk the run with you, check tension by hand, confirm gates latch clean, and take away the spoil. You get the whole look before we pack up. Any correction happens that day, not on a callback three weeks out.
Inspection and close-out
Where a permit was pulled, the inspection happens on the county’s schedule, not ours. We handle the paperwork and the callback, and we don’t leave you holding the paperwork. Everything we install sits under our 730-Day Done Right Promise, so if it’s not right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
Chain link is a narrow product compared to other fencing, which is good news. Few choices, and each one has a clear trade-off.
- Height (4, 5, or 6 feet). Four foot is the standard residential run and the cheapest per foot. Five and six foot read more like a barrier and cost roughly 15 to 30 percent more on the same linear footage. Local HOA rules matter here, so check your community’s approved height before we order.
- Wire gauge (11.5, 12.5, or 9). 11.5-gauge is the workhorse for residential jobs; 12.5-gauge is a step lighter and sags sooner under climbing. 9-gauge is commercial weight and overkill for most backyards, but useful along a busy run where dogs push on it.
- Coating. Galvanized steel holds up fine in shaded runs. In full South Florida sun and salt air, vinyl-coated (typically green or black) lasts longer on the finish and blends with landscaping. The color choice is often what an HOA or neighbor actually cares about.
- Gate style and size. A walk gate (3 to 4 feet) swings easily and costs less; a drive gate (10 to 12 feet) needs heavier posts and a stouter frame. If you have a pool, a self-closing, self-latching gate is required by code, and we build to that spec.
- Top rail and tension wire. A top rail keeps the run rigid and stops sagging over the years; a bottom tension wire locks the mesh to grade so a dog can’t push underneath. Both are worth the small extra on a residential run.
Where builders’ hardware and gate components come up, we use trusted partners like Barrette where it fits the spec, and we don’t sub in a brand you didn’t sign off on.
What a Chain Link Fence costs in Three Lakes, FL
For a typical residential lot, expect $3,500 to $9,000 installed. Small runs on the low end, larger perimeter jobs with multiple gates on the high end. Here’s what pushes the number one way or the other:
| Factor | Effect on price |
|---|---|
| Linear footage | Biggest driver. A 100-foot run and a 250-foot run are different jobs no matter what else is true. |
| Fence height | 4 ft is baseline; 5 and 6 ft add roughly 15 – 30% over the same footage. |
| Wire gauge | Standard 11.5 ga. vs heavier 9 ga. can shift a run by several hundred dollars. |
| Gate count and type | Each gate adds cost; a drive gate costs more than a walk gate because of posts and hardware. |
| Site prep | Removing an old fence, stump grinding, or grading a slope adds labor. |
| Permit scope | A county permit with an inspection adds cost over a job with none required. |
Your written estimate should spell out linear footage, height, gauge, coat color, gate sizes and types, and whether removal of the old fence is included or priced separately. What typically isn’t included unless we list it: stump removal, extensive grading, and any concrete work under the gate posts, which is where the driveway and hardscape side of the project can come in – homeowners often pair this with Concrete Driveways & Concrete Work in Three Lakes when gate posts and a widened drive need to line up. Front-yard runs along an asphalt or paver drive often land in the same conversation as Asphalt Driveways & Resurfacing in Three Lakes. Upfront pricing means the number in the quote is the number you pay, and 0% financing for 18 months is available if spreading the cost helps.
See the difference
Before
After
Before
After
Before
AfterWhat Three Lakes homes specifically do to this job
Three Lakes is a built-out pocket of western Kendall, mostly 1980s and 1990s concrete-block homes with barrel-tile roofs on tight HOA lots. Very little here is new ground-up building, so almost every fence project involves working around an existing property line, an HOA architectural review, and a county permit. When a permit is required, it runs through Miami-Dade County’s post-Surfside review and product-approval process, and the fence has to satisfy the community’s guidelines on height, color, and placement, not just the county code. On the older streets off Southwest 137th Avenue and around the lake-adjacent villas, we commonly find an original chain link run that’s 30-plus years old, posts heaved from root growth, and galvanized coating that’s chalked out from sun and salt air. Storms from May through November shorten the working window and can push a start date, which is why we set post and cure days early in the schedule. If your project is part of a full Fence Installation in Three Lakes plan that also touches gates or replacing an aging perimeter, we scope the pieces together so the fence and the rest of the yard work don’t fight each other.
Serving Three Lakes, FL – Our Local Coverage Area
We serve Three Lakes and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Chain Link Fence in Three Lakes
Most residential jobs go up in one to three days of on-site work, with the concrete cure day sitting between post-setting and mesh. Add the county permit turnaround on top of that if one is required for your run. Call (844) 761-9356 for a real timeline against your lot.
Sometimes. Fence permits depend on height, location, and whether the run sits in a platted easement or on a corner lot, and HOA rules often sit on top of the county requirement. We check both before we order material because pulling a permit after the fact is a headache for you. Call (844) 761-9356 and we’ll talk through what applies to your address.
Not on a written line-item estimate. The footage, height, gauge, coating, and gates get priced up front, and the number you see is the number you pay. Unforeseen conditions do come up (buried utilities, an old fence that’s set in deep concrete), and we flag them and price them with you before touching anything, never after. Schedule a free estimate at (844) 761-9356.
Yes. That’s the main thing we handle on Three Lakes jobs: reading the community’s architectural-review rules first, then building to the approved height and coat color so you pass the review and avoid a violation notice. We bring the approved spec to the estimate, not a guess. Call (844) 761-9356 for a free on-site look.
Every chain link fence we install is covered by our 730-Day Done Right Promise, so if it’s not done right, we make it right. Our technicians have up to 12 years of experience, are background-checked, and arrive in uniform. For a written quote on your run in Three Lakes, call (844) 761-9356.
Get a free estimate on your chain link fence
We start with a free on-site walk of your property line, confirm what your HOA will approve, and hand you a written line-item estimate for the exact footage, gauge, and gates. No pressure, no change orders. Call (844) 761-9356 – a live person answers 24/7 – and we’ll set the visit at a time that works. That’s the whole ask: a free estimate on a Fence Installation job done right the first time.
Written by the team at Groundwork Construction Co.