Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Kitchen Remodeling: The The Hammocks Owner’s Guide
Therma-Tru doesn’t make kitchen cabinets or countertops. What Therma-Tru makes is entry and patio door systems, and in a kitchen remodel those doors are the first thing people notice and the last thing most contractors get right. In The Hammocks, a full kitchen remodel runs $14,000 – $45,000, and swapping or upgrading the door system that ties into that space typically fits within that range once framing, trim, and finish work are included.
Owners usually find this page after a frustrating sequence. The kitchen is torn open, the old door is out, and the replacement unit doesn’t line up with the rough opening, or the patio door from the kitchen to the lanai starts sticking every summer. Sometimes the door was installed years ago and the frame has begun to warp from humidity. Either way, the part is the problem, and matching it correctly to the Therma-Tru system is what this page is about.
Which Therma-Tru Models This Applies To
Therma-Tru’s residential line covers fiberglass and steel entry doors, patio sliders, and French door systems. The common series The Hammocks homeowners ask about include the Fiber-Classic and Smooth-Star entry lines, the Classic-Craft door series, and the fiberglass patio door systems used as kitchen-to-lanai transitions. Each series has its own rough-opening tolerances, jamb depth, sill configuration, and hardware prep, so a part pulled for one series won’t fit another.
Start by finding the label. Therma-Tru stamps the series and rough-opening dimensions on a sticker on the hinge jamb or door slab edge. If the label is gone, measure the rough opening (frame to frame, top to sill) and the slab thickness. Most Therma-Tru patio sliders sit at 1¾-inch slab thickness, and entry slabs run 1¾ inches as well, but the rough-opening spec varies by series and frame type.
OEM vs. aftermarket is where owners get into trouble. Therma-Tru OEM parts (sills, sweep kits, rollers, weatherstrip, hinges) match the factory tolerances exactly. Aftermarket equivalents are cheaper and sometimes work, but the fit degrades faster in Florida heat. For a door system that has to survive The Hammocks humidity and summer heat cycles, OEM or OEM-spec parts are the safer call. We also install KraftMaid, Cambria, and Silestone on the kitchen side, so if the door swap happens during a full remodel, one crew coordinates the whole scope. Groundwork Construction Co. of The Hammocks is an independent service provider, not affiliated with Therma-Tru.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Kitchen Remodeling Is Failing
- The door sticks or drags after summer heat arrives. Fiberglass and steel slabs expand with heat, and if the frame wasn’t shimmed and anchored correctly, the slab racks against the jamb. In The Hammocks, this usually shows up in June and eases in November.
- Daylight or water at the sill corners. A failed sill or sweep lets rain in. Once water reaches the subfloor at a kitchen-lanai transition, the damage spreads to tile and cabinet toe kicks.
- The patio slider binds on its track. Worn rollers or a track that’s picked up grit and sand cause this. Left alone, the rollers flatten and the slab stops sliding altogether.
- Weatherstrip is cracked, compressed, or peeling away from the frame. UV exposure destroys foam and rubber seals faster than most homeowners expect. A compromised seal breaks the door’s air and water rating.
- Fogging or condensation inside the glass unit. That means the sealed glazing unit has failed. It can’t be repaired, only replaced, and the door or panel has to come out to do it properly.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In The Hammocks, a Therma-Tru-compatible door system replacement tied into a kitchen remodel typically runs within our kitchen remodel band of $14,000 – $45,000 when bundled with cabinet and countertop scope. A stand-alone entry or patio door swap falls on the lower end. Here’s what drives the range:
- Door series and glass package: a Smooth-Star entry slab prices below a Classic-Craft with decorative glass.
- Frame and trim scope: replacing the full frame and trim costs more than a slab-only swap.
- Rough opening condition: rot, water damage, or an out-of-square opening adds repair time before the new unit goes in.
- Finish and hardware: factory finish and upgraded hardware add cost but reduce long-term maintenance.
You get upfront pricing, a written line-item quote, and the number you see is the number you pay. All work is covered by the 730-Day Done Right Promise. Financing is available at 0% for 18 months, plus $1,000 off projects over $10,000.
DIY or Call Us?
You can safely check the basics yourself. Look for the label on the hinge jamb, measure your rough opening, and inspect the weatherstrip and sill for cracks or daylight. Writing those measurements down before you call saves time on the estimate and helps us match the right part.
Where DIY goes wrong is the install itself. A door system has to be plumb, level, and square within a sixteenth of an inch. If it’s off, the door won’t seal, the frame will warp, and the water intrusion starts. Weight and glass add injury risk, and on a lanai slider the work involves removing a heavy slab and resetting it without breaking the track. That’s not a weekend job. Call (844) 761-9356 to schedule your free estimate. We’ll match the part, pull the permit if one is required, and install it once.
FAQs
Expect 15 – 20 years from a quality Therma-Tru fiberglass entry door in The Hammocks, with the weatherstrip, sweep, and rollers needing replacement every 5 – 8 years. UV exposure and salt-laden air speed up wear on seals and hardware. Call (844) 761-9356 for an inspection and a written quote.
Often, yes. Weatherstrip, sweeps, rollers, hinges, and sills are replaceable and cost far less than a new door. Fogged glass or a warped frame means replacement. We’ll tell you honestly which case you’re in before any work starts. Call (844) 761-9356 for a free estimate.
A slab-only replacement is typically a single visit. A full frame-and-door replacement usually takes a day, plus finish work. We’ll confirm timing when we see the opening. Call (844) 761-9356 to schedule.
We match the part to your series and rough-opening spec, then source it through verified supply partners. We don’t claim to carry parts in stock. If OEM is available, we quote OEM. If a quality OEM-spec equivalent fits your budget, we say so. Call (844) 761-9356 for a free estimate.
Ready to get the door right? Call (844) 761-9356 to schedule your free estimate with Groundwork Construction Co. of The Hammocks. We’ll measure, match the Therma-Tru part, and give you a written line-item quote with upfront pricing. Every job is backed by the 730-Day Done Right Promise, and our technicians have up to 12 years of experience handling door systems and kitchen remodels across The Hammocks.
Written by the team at Groundwork Construction Co. of The Hammocks, serving The Hammocks and nearby areas.