Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Moen Windows & Doors: The The Hammocks Owner’s Guide
We install Moen-compatible windows and doors for The Hammocks homeowners, and a typical full replacement here runs $4,500 – $15,000 for standard window replacement or $8,000 – $25,000 for impact-rated units. The specific part you’re chasing – a failed hinge, a worn lock, a broken sash balance, a shot weather seal or a warped door slab – usually sits at the low end of a repair ticket, and most straightforward swaps are done in a single visit. Owners in The Hammocks tend to notice the failure the same way: a window that won’t stay up, a door that won’t latch flush, a draft that wasn’t there last summer, or water staining the sill after an afternoon storm.
Which Moen Models This Applies To
Moen’s window and door hardware line is trickier to pin down than their faucets, because part numbers change with the series and with the era of the home. In The Hammocks, a lot of the housing stock went up in the 1980s through the 2000s, which means you’re often dealing with a first-generation hinge set or an original slab that’s been painted over twice. The fastest way to identify the right part is to pull the model and series number off the label on the window frame or the door edge, then measure the existing hardware yourself – hinge screw spacing in millimeters, sash balance length and tension rating, lock backset. Guessing from a photo is how people end up with the wrong part twice.
Your OEM-versus-aftermarket decision matters more with Moen than with most brands. OEM parts match the original fit and finish exactly, which is what you want on a visible lock or hinge. Quality aftermarket equivalents can save real money on internal components like sash balances or weather seals where the tolerances are looser and the part isn’t seen. We won’t tell you one is always right – it depends on the part and how long you plan to stay in the house.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Moen Window or Door Hardware Is Failing
- Window won’t stay open. That’s a spent sash balance or a snapped tension spring. The window becomes a falling hazard, not just an annoyance.
- Door drags or won’t latch flush. Usually a sagging hinge or a hinge plate pulling out of softened wood. Left alone, it wears the frame and the strike plate.
- Draft or water intrusion at the seal. A compressed or cracked weather strip. In The Hammocks humidity, a failed seal lets moist air in and you get condensation and mold at the sill.
- Lock or handle turns hard or won’t fully engage. A worn lock cylinder or a misaligned strike. A lock that doesn’t fully engage is a security gap.
- Visible rot or soft spots on the door slab or frame. Water has been getting behind the hardware. This is the one that turns a parts swap into a replacement.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included in The Hammocks
Installed pricing in The Hammocks lines up with the ranges we quote everywhere in our market. Standard window replacement runs $4,500 – $15,000. Impact window installation – which a lot of The Hammocks homeowners end up choosing given the storm exposure – runs $8,000 – $25,000. What drives the range is unit count, whether you’re doing a single failed part or a full opening, the glass spec, and whether the frame is sound enough to reuse.
Our quotes are line-item and upfront. You see the part cost, the labor, and the disposal separated out, and the number you see is the number you pay. Every install is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s on the workmanship, in writing, for two full years.
Typical The Hammocks price ranges:
- Window replacement (full job): $4,500 – $15,000
- Impact window installation: $8,000 – $25,000
- Single hardware or part swap: low end of a repair ticket, quoted per job
DIY or Call Us?
Some of this you can safely check yourself. Measure the hardware, photograph the label, test whether the window stays up, confirm the door is actually racked or just painted shut. That information helps us quote accurately and saves you a diagnostic trip.
Where DIY goes wrong: sash balances are under real spring tension, and a snapped balance can whip back and cut a hand or break glass. Door slabs are heavier than they look, and dropping one on a toe or through a window is a common weekend-injury story. Replacing a lock cylinder wrong leaves you less secure than you started. We’d rather you call than hurt yourself or crack a pane.
Call (844) 761-9356 and a live person picks up – around the clock, every day. No voicemail, no waiting until Monday.
FAQs
Expect 10 – 15 years out of hinges, locks and sash balances in this climate, less if the unit faces the afternoon sun or sits on the windward side of the house. The Hammocks salt air and humidity accelerate corrosion on metal parts faster than you’d see inland. Call (844) 761-9356 for a free assessment of what you’ve got.
Often yes – a hinge swap, a re-tensioned balance, or a new weather seal will get you years more out of a sound window or door. If the slab or frame has rot or the glass seal is blown, repair stops making financial sense. We’ll tell you which side of that line you’re on before you spend anything. Call (844) 761-9356.
A single part swap is usually done in one visit, often under an hour for a hinge or lock. Full window or door replacements depend on count and whether the opening needs framing work. We’ll give you a realistic timeline with the quote – no vague “sometime next week.”
We match the exact model and series from your label and measurements, then order OEM or a verified aftermarket equivalent based on what you choose. We don’t claim to stock parts or carry them on a truck – we source to your unit so it fits the first time. Call (844) 761-9356 and we’ll confirm availability before you commit.
Groundwork Construction Co. of The Hammocks is an independent service provider and is not affiliated with Moen. We also work with KraftMaid, Cambria and Silestone on other projects.
Ready for a straight answer on your Moen part? Call (844) 761-9356 for a free estimate – live person, 24/7, upfront pricing with no surprises.
Written by the team at Groundwork Construction Co. of The Hammocks, serving The Hammocks and nearby areas.