Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in South Miami Heights, FL: What It Costs and How Long It Takes
A Tub-to-Shower Conversion in South Miami Heights typically runs $4,130 to $11,800 and takes five to nine working days from demo to final inspection. The job means pulling the tub and its surround, reworking the drain and valve wall to shower code, waterproofing the wet area, and setting a new shower base, walls, and door or curtain opening. Most of our conversions here sit in the middle of that range. Call Groundwork Construction Co. at (844) 761-9356 for a free on-site estimate.
How the Work Actually Runs, Stage by Stage
Conversions look simple on paper and rarely are. On a 1970s CBS home in South Miami Heights, the tub alcove usually hides surprises: a cast-iron drain past its life, drywall where there should be cement board, or a valve that was never replaced when the fixtures were. Here is the sequence we follow and where you make decisions.
Stage 1: Demo and discovery (day 1, sometimes day 2). We protect the floors and the path to the front door, shut the water, and remove the tub, surround, and valve trim. Then we open the wall to the studs at the wet wall. This is where you find out whether the drain rough-in and the valve are reusable or not. If the plumbing is original to a 1970s build, plan on replacing both. You’ll decide nothing during demo; we’ll show you photos of what we found and price any change before touching it.
Stage 2: Rough-in and inspection (day 2 or 3). The drain gets converted from a tub overflow-and-waste setup to a shower drain, which means cutting the slab or raising the base depending on what’s under the tub. The valve gets swapped to a pressure-balance or thermostatic unit, because a shower needs anti-scald protection a tub never did. Miami-Dade County inspection happens at this stage if the scope requires it. You choose the valve brand and finish before this day – it’s the one decision that stalls jobs when it’s made late.
Stage 3: Waterproofing (day 3 or 4). This is the stage nobody sees and the one that decides whether the shower lasts. We install cement backer board, then a bonded sheet or liquid-applied waterproofing membrane over the entire wet area, with fabric at the corners and the curb. A pre-sloped shower pan or a manufactured base goes in with the drain collar properly clamped. This gets a flood test on many jobs. If a contractor skips this stage, you’ll be looking at mold in the wall cavity within a couple of seasons in South Florida humidity.
Stage 4: Tile and setting (days 4 through 7). Wall tile, grout, and the shower floor go in. Larger-format tile means fewer grout lines to clean but demands flatter walls, so it costs more in prep. This is where you pick your tile, grout color, and whether you want a niche or a bench. We set the schedule around your selections; tiles that arrive late push everything back, so lock your choices before demo day.
Stage 5: Glass, trim, and walkthrough (days 7 through 9). The shower door or curtain rod goes in, along with the valve trim, drain cover, and any grab bars. We test the valve, check the slope drains fully, and do a final walkthrough with you. You get the written workmanship coverage at that point. Most South Miami Heights conversions land in this window unless the slab or plumbing fights back.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Everything below changes the price and the lifespan of the shower. These are the real trade-offs, not a catalog.
- Tile vs. solid-surface walls. Porcelain tile runs $8 to $30 per square foot installed and gives you the widest selection. Acrylic or solid-surface panel systems cost less in labor and go in faster, but they show scratches and look less custom. For a rental or a quick flip in South Miami Heights, panels make financial sense. For a home you’ll stay in, tile wins.
- Standard base vs. custom mud-set pan. A manufactured base is fast and predictable. A custom pan lets you size the shower to the alcove exactly and tile the floor, but it adds a day of labor and requires a skilled setter. Both work; one is a budget call, one is a finish call.
- Valve and fixture grade. A basic pressure-balance valve is fine. A thermostatic valve with a separate volume control costs more but holds temperature through a pressure drop, which matters in a busy household. Kohler and Moen both make solid mid-range units; the brand matters less than getting it inspected and sealed correctly.
- Framed vs. frameless glass. Frameless looks cleaner and holds up better against mildew at the seams. It costs roughly 40% more than framed. In a small alcove, frameless opens up the space visually; in a shared family bathroom, framed glass with a towel bar is the practical pick.
- Niche, bench, and grab bars. Each adds cost but each adds daily use value. A recessed niche keeps bottles off the floor. A bench or grab bar helps anyone with mobility concerns, and it’s far cheaper to install during the build than to retrofit later.
What a Tub-to-Shower Conversion Costs in South Miami Heights, FL
Plan on $4,130 to $11,800 for the conversion itself, with a typical South Miami Heights job landing near the middle. Here is what the number covers and where it splits.
What’s included in a written estimate: demo and haul-away, drain and valve rough-in, waterproofing and backer board, a standard shower base, wall tile up to a stated square footage, grout and sealant, a shower door or rod, fixture trim, and cleanup. We put line items on paper so you can see what each piece costs, and that price doesn’t change mid-job unless you change the scope.
What pushes a job to the low end: keeping the existing valve and drain if they pass inspection, a manufactured base, acrylic or standard tile walls, and a framed door. A straightforward alcove shower on a house where the plumbing is already sound lands near $4,130 to $6,000.
What pushes it to the high end: relocating the drain (slab cutting), upgrading to a thermostatic valve, custom mud-set pan, large-format or natural stone tile, frameless glass, and a niche or bench. Any of those alone adds a few hundred to a couple thousand; stacked together, they take you toward $11,800.
What’s usually not included: structural repairs found after demo, mold remediation, moving a wall, or adding a vent fan where none exists. We price those as written change orders before any work continues.
See the difference
Before
After
Before
After
Before
AfterWhat South Miami Heights Homes Specifically Do to This Job
South Miami Heights is mostly single-family, owner-occupied, and built out between the 1970s and 1990s. That build era is the whole story for a tub-to-shower conversion here. Those homes are concrete-block with stucco, and the bathroom plumbing inside is often original copper or early PVC. When we open a wall in a 1978 home off Southwest 184th Street or near South Miami Heights Park, we’re routinely replacing a valve that was never designed for shower pressure. The good news is that block construction means the shower walls are solid and the alcove fits a real custom pan.
Two local realities shape every job in ZIP 33177. First, Miami-Dade County permitting and inspection: a tub-to-shower conversion that moves the drain or valve requires a plumbing permit, and the county inspects the rough-in before tile goes up. Older homes here also carry the county’s 40-year (now 50-year) building recertification history, and if a bathroom is part of a larger project, that paperwork burden can affect the schedule. Plan a week of buffer for the inspection window. Second, the climate: year-round humidity means mold-resistant assemblies, proper ventilation, and a fan that actually vents outside are not optional. A bathroom without an exterior-venting fan in this humidity will grow mold within a couple of years no matter how good the tile looks. When homeowners are also fixing the envelope, they often pair this work with our Metal Roofing in South Miami Heights so the whole house is tightened up at once.
Housing stock in South Miami Heights is largely 1970s-1990s single-family concrete-block homes with stucco exteriors and flat or low-slope roofs, and the work here is driven by upgrades and code-compliant rebuilds rather than new construction. If your conversion is part of a wider scope, or you’re converting a guest bath alongside a primary, this fits naturally inside a full Bathroom Remodeling in South Miami Heights project. We cover the whole of South Miami Heights and the surrounding area, from the neighborhoods off US-1 to the streets near Larry and Penny Thompson Park.
Serving South Miami Heights, FL – Our Local Coverage Area
We serve South Miami Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked about Tub-to-Shower Conversion in South Miami Heights
Most conversions take five to nine working days, with the inspection window adding a week of buffer. Demo takes a day, rough-in and inspection another, waterproofing a day, and tile and glass the remaining days. Call (844) 761-9356 to get a schedule for your bathroom – estimates are free.
Yes, if the drain or valve rough-in changes, Miami-Dade County requires a plumbing permit and inspection. A pure finish swap over the same drain with no plumbing change can sometimes proceed without a plumbing permit, but the county has the final say. We pull the permit and coordinate the inspection so you’re never chasing paperwork. Call (844) 761-9356 to confirm what your job needs.
Sometimes. If the existing drain and valve pass inspection, we can often keep them and save you both money and time. On 1970s South Miami Heights block homes, though, that plumbing is frequently past its service life, and reusing it means opening the wall again in a few years. We’ll tell you straight during demo. Call (844) 761-9356 to have us look before you commit.
Conversions here run $4,130 to $11,800, with most jobs landing in the middle. Keeping the existing plumbing and choosing standard finishes keeps you near the low end; moving the drain, upgrading the valve, and adding frameless glass pushes you toward the top. Call (844) 761-9356 for an exact written quote – the number you see is the number you pay.
Every conversion is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, for two full years. That covers the waterproofing, tile, and fixture installation we perform. Call (844) 761-9356 with any warranty question and a live person will answer.
Schedule Your Tub-to-Shower Conversion Estimate
A free on-site estimate takes about 45 minutes. We measure the alcove, open nothing yet, look at the plumbing and venting, and hand you a written line-item quote with a firm price and a realistic schedule. No pushy upsells, just straight numbers. Call Groundwork Construction Co. at (844) 761-9356 to book your estimate for a Tub-to-Shower Conversion in South Miami Heights, and we’ll walk you through every stage before you commit.
Written by the team at Groundwork Construction Co.