Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boxabl Kitchen Remodeling: The The Hammocks Owner’s Guide
We install Boxabl-compatible kitchen components in The Hammocks for $14,000 – $45,000, with most jobs being a planned remodel rather than a same-day repair. That range covers cabinet replacement, countertops, backsplash, and in some cases a new island. The number depends on how far you go: a cabinet-and-countertop swap lands at the low end, while a full gut with new plumbing connections at the island pushes higher.
Owners in The Hammocks usually discover a failed component one of two ways: soft spots and swelling along the cabinet bases after a wet season, or a countertop seam that has opened up enough to catch a fingernail. Boxabl units are tight, well-insulated, and efficient, but they’re not immune to South Florida humidity. The kitchen is where that shows up first, because it’s where water, steam, and daily traffic all land in the same 60 square feet.
We’re an independent service provider, not affiliated with Boxabl. We work on the kitchen side of these units and can tell you honestly what’s compatible, what isn’t, and what your money buys in The Hammocks.
Key Takeaways
- Typical installed range in The Hammocks: $14,000 – $45,000 for Boxabl kitchen remodeling.
- Cabinet installation alone runs $4,000 – $13,000; countertops $2,000 – $6,500; backsplash $800 – $2,500.
- Florida humidity is the main driver of premature cabinet failure in Boxabl kitchens.
- Every project is covered by our 730-Day Done Right Promise.
Which Boxabl Models This Applies To
Boxabl’s Casita and its larger configurations share a common kitchen footprint: a compact galley-style run along one wall with an appliance stack and, on some layouts, a small island or peninsula. The core module dimensions are what matter here, not the model name on your paperwork. Measure the inside face of the cabinet run from end panel to end panel, then measure the height from finished floor to underside of counter. Standard Boxabl runs sit in a narrow band that doesn’t always match conventional American cabinet sizing, and that’s the first compatibility gotcha most owners hit.
To identify what you have, look for the serial label inside the cabinet door or on the inside of the end panel. It gives you the module build date and, on most units, the cabinet supplier code. Photograph that label before you call anyone; it’s the fastest way to confirm the right replacement spec. If the label is gone, a photo of the cabinet box with a tape measure across it tells us almost as much.
The OEM-versus-aftermarket call is where Boxabl owners get talked into the wrong thing. Original-spec replacements match the unit’s engineered tolerances exactly, which matters for door alignment and drawer glide fit. Quality aftermarket boxes can match those tolerances if they’re built to the right dimensions, and they often give you better finishes and hardware for the money. What you don’t want is a big-box cabinet line cut down to fit. That’s where swelling starts.
We also work with KraftMaid, Cambria, and Silestone on conventional kitchens in The Hammocks, and those material lines apply to Boxabl-compatible builds where the dimensions allow. The point is matching the spec to your unit, not selling you a brand.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Boxabl Kitchen Remodeling Is Failing
Kitchen components don’t fail overnight. They give you warnings, and in The Hammocks those warnings tend to arrive in the same order every time.
- Cabinet boxes swelling at the bottom. Particleboard and MDF cores absorb moisture and expand permanently. It happens in The Hammocks because the humidity swings between a dry January and a soaked August cycle the material never fully dries out.
- Doors that won’t stay aligned. When a cabinet box swells or the unit settles, hinges lose their reference point. You adjust once, and three weeks later the door is sagging again.
- Countertop seams opening. Butt joints and laminate seams lift when the substrate beneath them moves. Once water gets into a seam, the core under the counter starts to break down.
- Caulk lines and backsplash separating from the wall. Continuous flex between cabinet and wall breaks the seal. That gap lets in the steam that causes the next problem on this list.
- Soft spots around the sink cutout. The sink opening is where water sits longest. Once the core softens, a simple re-caulk doesn’t fix it, because the material under the caulk is already gone.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Boxabl kitchen remodeling in The Hammocks runs $14,000 – $45,000 installed. The range is driven by scope, not by model. Here’s how the line items break out, and what drives each one:
| Line Item | Installed Range in The Hammocks | What Drives the Number |
|---|---|---|
| Small kitchen remodel | $9,000 – $20,000 | Single-wall run, minimal plumbing changes |
| Cabinet installation | $4,000 – $13,000 | Box count, door style, soft-close hardware |
| Countertop installation | $2,000 – $6,500 | Material choice, edge profile, cutout count |
| Backsplash installation | $800 – $2,500 | Tile size, pattern complexity, prep needed |
| Kitchen island installation | $3,000 – $10,000 | Size, whether electrical runs to it |
Those are installed prices, parts plus labor, written into a line-item quote before we start. Upfront pricing, no surprises: the number you see is the number you pay. Every project carries the 730-Day Done Right Promise, so if something’s not done right, we come back and make it right.
DIY or Call Us?
You can safely check a lot of this yourself. Open cabinet doors and run your hand along the bottom panel for soft spots. Photograph the serial label. Measure the cabinet run and counter height. Test drawer glides for wobble. Fill out the diagram of what’s failing. That’s information we can price from, and it costs you nothing.
Where DIY goes wrong is installation. Moving a sink line or a dishwasher feed without the right shutoff means water damage in a unit that’s already tight and hard to dry out. Cutting a countertop cutout wrong means a $2,000 slab in the trash. And on the electrical side, if your island has outlets, the circuit work should go to a licensed professional. We’d tell you the same thing straight: some of it is a weekend project, and some of it is a phone call.
Call (844) 761-9356 and we’ll walk through what you’ve got. Live person, every time, around the clock. Estimates are free.
FAQs
Cabinet boxes typically hold up 10 – 15 years in South Florida humidity, provided the sink and backsplash seals stay intact. Once a seal fails and water gets in, the material degrades in months, not years. Countertops last much longer if seams are maintained.
Sometimes. A swollen cabinet box cannot be repaired; it has to be replaced. A countertop with a failed seam can sometimes be re-sealed. We’ll give you the honest answer before you spend money.
A cabinet and countertop replacement typically runs several days from tear-out to final walkthrough, depending on counter material lead times. A full kitchen remodel runs longer. We give you a schedule before we start.
From the serial label inside your cabinet door plus measurements of the cabinet run and counter height. That combination confirms the spec. We don’t carry parts on a truck; each job is sourced to your unit.
Call (844) 761-9356 to schedule your free estimate in The Hammocks. Live person, 24/7, and a written line-item quote you can hold us to.
Written by the team at Groundwork Construction Co. of The Hammocks, serving The Hammocks and nearby areas.