Bathroom remodeling
Kitchen remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Bathroom Remodeling: The The Hammocks Owner’s Guide
Bathroom remodeling built around Tamko materials in The Hammocks typically runs $9,000 – $28,000 installed, with most full baths landing in the middle of that range once waterproofing, tile, and fixtures are included. We handle the whole scope: tear-out, moisture barriers, shower and tub work, flooring, vanity, and ventilation. Most projects are scheduled across several days, not a single visit, because proper waterproofing and tile work need curing time between stages.
How do most owners find out something’s wrong? Water where it shouldn’t be. A soft spot at the shower curb, grout that keeps coming back, a ceiling stain below the bathroom floor, or caulk that pulls away within weeks of a patch. In The Hammocks, the trigger is almost always the same: a moisture barrier or flashing detail that failed long before the tile above it started to show it.
Which Tamko Models This Applies To
Tamko is best known for roofing and waterproofing products, and homeowners in The Hammocks most often encounter their materials at the moisture barrier layer – underlayments, waterproofing membranes, and accessory flashing that sit beneath the finished tile or floor. If your home was built or re-roofed with Tamko underlayment, that same moisture-control philosophy is what we match when we rebuild a bathroom wet area.
Identifying the right material starts with the label. Look for the Tamko product name on the wrap, roll edge, or installation paperwork left by the original builder. If the label is gone, we measure the actual substrate dimensions and check the assembly context – shower pan, tub surround, or floor – rather than guessing from appearance alone. Series compatibility matters: a membrane spec’d for one substrate type won’t perform the same over another, and the wrong pairing is a common source of premature failure.
OEM versus aftermarket is a real decision. Tamko-branded materials are consistent and easy to warranty-match, but quality equivalents from established manufacturers perform comparably when the installation detail is right. What matters most is matching the product to your substrate, your climate exposure, and the tile or flooring going over it. We’re an independent service provider, not affiliated with Tamko, so we recommend what fits your assembly – not what’s easiest to source.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Bathroom Remodeling Is Failing
South Florida humidity and the daily wet-dry cycle inside a bathroom are hard on any moisture assembly. Here’s what failure looks like before it becomes a tear-out:
- Grout cracking along the shower floor or curb. Movement under the tile – often a substrate or membrane that wasn’t properly bonded – lets the assembly flex. The crack is the symptom; the layer beneath is the cause.
- Soft or spongy spots near the toilet flange or shower drain. Water has reached the subfloor. In The Hammocks, this usually traces to a failed drain seal or a flashing detail that was never lapped correctly.
- Peeling caulk that returns within weeks. Recaulking over a damp, failing substrate never holds. The moisture is coming from behind, not from the bead itself.
- Musty smell that lingers after cleaning. That’s trapped moisture in the wall cavity or floor assembly – often a vapor barrier that’s torn, poorly lapped, or missing at a corner.
- Staining or bubbling on the ceiling below the bathroom. The clearest sign water is escaping the assembly entirely. This one moves fast and shouldn’t wait.
Replacement Cost & What’s Included
Full bathroom remodeling in The Hammocks runs $9,000 – $28,000 installed. Smaller baths land in the $5,000 – $12,000 range. Here’s what drives the number:
- Scope. A cosmetic refresh sits at the low end; a full gut with new waterproofing, tile, shower, and vanity sits at the high end.
- Wet-area work. Walk-in showers run $4,500 – $12,000; tub-to-shower conversions $3,500 – $10,000; shower replacements $3,000 – $8,500.
- Fixtures and finishes. Vanity installation runs $800 – $3,000, and tile selection moves the total more than most homeowners expect.
- What’s behind the wall. Water damage found during tear-out is quoted transparently, not buried in a change order.
Every project is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. Upfront pricing means the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some things you can safely check yourself: look for the product label on exposed underlayment, measure your shower or tub opening, note where water is showing up, and photograph the failure points. That information makes the estimate faster and more accurate.
Where DIY goes wrong: rebuilding a wet area. Waterproofing a shower or tub surround is not a caulk-and-tile job. Membranes have to be lapped in a specific order, drain connections have to be set to the right height, and one missed detail behind a wall means the whole assembly comes back out months later. We’ve torn out plenty of weekend projects in The Hammocks that failed at exactly that layer. If water is already reaching the subfloor or the ceiling below, stop and call.
Call (844) 761-9356 – a live person answers 24/7, and estimates are free and upfront.
FAQs
A properly installed moisture assembly typically lasts 20 to 30 years, but in South Florida humidity that’s contingent on ventilation and the installation detail. Bathrooms without a working exhaust fan routinely fail years earlier. Call (844) 761-9356 for an assessment – the estimate is free.
Sometimes – a localized drain seal or a single compromised corner can be repaired if the damage hasn’t spread to the subfloor. Once water has reached framing or flooring beneath, partial repair usually costs more over time than a proper rebuild. We’ll tell you honestly which situation you’re in.
A focused shower or wet-area rebuild typically runs several days to about a week, depending on curing time between waterproofing and tile. A full bathroom remodel takes longer. No reputable contractor finishes a proper wet-area rebuild in a single visit – curing matters.
We match materials to your specific assembly and substrate, then source them through verified supplier relationships with written specs on file. We don’t claim to stock parts or carry inventory on a truck – every material is specified for your project and delivered for installation. We also work with KraftMaid, Cambria, and Silestone for vanity and finish selections.
Get Your Free Estimate
If your bathroom is showing the signs above, don’t wait for the ceiling stain to get worse. Call (844) 761-9356 to schedule your free project estimate and design consult. A real person answers around the clock – no voicemail, no waiting until Monday. Our technicians bring up to 12 years of experience to every job, arrive background-checked and in uniform, and every project is backed by the 730-Day Done Right Promise. Upfront pricing, 0% financing for 18 months, and $1,000 off projects over $10,000 mean you can plan the remodel without the guesswork. From foundation to finish line, built to last and backed in writing.
Written by the team at Groundwork Construction Co. of The Hammocks, serving The Hammocks and nearby areas.